Electrical Connection
FOR PROPER ELECTRICAL CONECTIONS, CHECK LOCAL BUILDING CODE. UNIT MUST BE INSTA LLED BY A QUA LIFIED LICENSED ELECTRICIAN
- Connect dryer to nearest distribution panel. Use wire as required by local electrical code. In the United States and Canada use No. 12 wire or larger.
- Wiring Instructions:
- This appliance is intended for connection to fixed wiring.
- A fused means for disconnection in all poles must be provided in the fixed wiring in accordance with the wiring rules.
- Check that the electrical rating shown on the Hand Dryer (rating label) is compatible with the electrical supply.
- WARNING: The 115 Volt Dryer MUST BE EARTHED.
- Installation and wiring must conform to current IEE Regulations (UK), local or appropriate regulation (other countries).
- For 115 Volt Dryers: Connect ground/earth supply the terminal marked , the Live supply to terminal marked L and neutral supply to terminal marked N. A Dedicated line is required for each 115 Volt dryer.
- For 208–240 Volt Dryers: Connect the 208-240 Volt wires to terminals marked L (L1) and N (L2).
- Secure electrical wire in strain relief clamp provided on mounting base.
Replace Cover
Fit cover over mounting base.
Note: Four sides of cover overlap the mounting base and should be flush with the sides, top and bottom of the mounting base.
Replace and tighten three screws, one on each side and one on the bottom to secure cover to mounting base.
Check Dryer Operation
Turn electrical power supply on.- Position hands under air-outlet, within 4'' (100mm) of the bottom of the dryer.
- Dryer should turn on. Warm air should blow from air-outlet.
- Remove hands from under air-outlet and dryer should stop (within 2 seconds).
Maintenance
- Exterior of cover should be cleaned with a damp cloth to remove dust and surface dirt. Do not use abrasive agents or solvents as they may permanently damage surface of cover.
- At least once every 6 months remove cover. Using a small brush or vacuum, clean out buildup of dust and lint from air-intake grille and baffle.
Note: if dryer is installed where there is a lot of dust and dirt in the air, the interior of the dryer should be cleaned out more frequently.
Warranty
IMPORTANT
LIMITED WARANTY
SAVE
Installation Date: ________________________________________________________________________________________________________
Serial No(s).:___________________________________________________________________________________________________________
Installation Address:______________________________________________________________________________________________________
Telephone No.:__________________________________________________________________________________________________________
The Bobrick B-710 CompacDryer™ of the serial number(s) indicated herein, and all parts are warranted to the original owner of the installed unit for five years from date of original purchase against defects in factory workmanship or material under normal use and service*.
This warranty is limited to repair or exchange of defective parts at the option of Bobrick.
THIS WARANTY DOES NOT COVER ACCIDENTA L DAMAGE, IMPROPER HANDLING OR INSTA LLATION , OR REPAIRS MADE BY UNAUTHORI ZED PERSONS, AND SPECIFICALLY EXCLUDES CLAIMS FOR INDIRECT, ACCIDENTAL OR CONSEQUENTIAL DAMAGES TO PROPERTY. THE IMPLIED WARANTIES OF MERCHANTA BILITY AND FITNES FOR A PARTI CULAR PURPOSE ARE LIMITED TO THE SAME DURATION OF THE ABOVE WARRANTY.
Some states do not allow the exclusion of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
* Normal service constitutes performing the following preventive maintenance procedure: Clean any lint, dust or grease from air-inlet and air-outlet grilles.
Labor costs for preventive maintenance shall be at owner's expense.
For repair or exchange of defective part, send the part together with installation date and serial number to BOBRICK.