- Drill out all the spring guide brackets welds. (If model has any).
Spring Guide Brackets - Drill out all lock angle welds. (If model has any)
Lock Angle - Drill out all bracket welds. (If model has any)
Bracket
- Pry out and remove the towel tray and guide, hinge half and door stop.
Hinge Half
Towel Tray and Guide
.
.
.
.
.
Lock Angle - File rough, sharp or uneven surfaces where drilling and cutting was performed.
- If using an AC Adapter (order part no. 3974-57) with module, use template to mark hole location on cabinet and drill a 7/8" hole for AC Adapter "lead wire" and fi le sharp edges afterwards.
- AC Adapter hole may also be made anywhere in cabinet to make electrical connection more convenient.
- Install cabinet back into the wall.
Important Note: There are two options when performing the following retrofi t procedure.
- Use template to mark module pilot holes and drill.
Module Keyhole Slot
选择一
Option 1
- Use Module screw locations as a template and mark 7 screw locations on cabinet.
- Requires you to hold the module inside cabinet as holes are marked.
- Use center of rectangular section of keyhole slots in module to mark 7 screw locations if using module inside cabinet to mark module mounting pilot holes
选择二
Option 2
- Use a paper or cardboard template mark 7 screw locations.
- Requires proper adhering of template to be sure module lines up correctly.
- Install one washer screw in the top center of the module to hold in place.
- Install the remainder washer screws.
- The two screws that are on the sides, towards the bottom of the module will be screwed in at an angle and will remain that way when tightened.
- On cabinets deeper than 4", using provided template, new holes can be made on the module closer to the front door to make it easier to install the module and will allow the lower screw heads to sit fl ush against the cabinet surface.
- Completed Automatic Universal Roll Paper Towel retrofi t unit.
